Make sure that the curved part of the plug is aligned with the curved part of the port. Added Windows USB3 compatibility Firmware Installation:īe aware of the orientation of the FireWire or USB plug when connecting it to the device. Added MIDI Thru control under SETUP menu If in doubt, post a screenshot of each.- Fixed FireWire FIFO noise when connected to a MacMini One final thing for now: If anything in the system is overclocked at all, especially cpu or memory, revert to factory defaults for testing purposes until you are confident about it being a cause or not.ĬPU-Z is an excellent and free piece of software to compare the current running memory speed and timings to what the factory intended it to run at. However, I don't suspect a video card issue. It can also not hurt to check the caps on the video card too, again, just for good measure. That being said, cap damage can not always been seen visually. Or even if the tops are not perfectly flat but have become rounded, that also is an issue. If you notice any brown crud (electrolyte) near the base or tops of them, you have a definite issue. And on top of that, I wasn't getting bsods in any other scenario.ġ) Upload new crash dumps to verify what might or might not be going on.Ģ) Get a nice flashlight and try to look at all the caps on the motherboard, especially ones that may be partially hidden under a heat sink. Just for the curious, my motherboard is socket LGA775 with P4 3.4 GHz, so I used these. These help to regulate the voltage to the cpu. Refusing to be stuck, I knew what it had to be.I replaced many of the critical capacitors on the motherboard with solid state (polymer) ultra low esr ones, especially the ones physically close to the cpu. So looking at the crash dumps anyhow for good measure, it was apparent that nothing specific was being blamed. Less than a year ago, I had the exact same issue with my MOTU and it puzzled me because I was absolutely 110% certain that all of my drivers were known well (not being on a high-horse or anything, but it's because I'm sort of an authority on it based on 10s of thousands of machines I've looked at for people, and my mental index based on versions and dates.)

Motu 828 mkii firmware update